Friday, April 27, 2012

How to assemble a Fondant Cake:

Step 1:
Each cake layer needs a sturdy base. Trace cake pans onto a piece of foam board three-sixteenths of an inch thick.

Step 2:
Bake cakes in parchment-lined cake pans, and let them cool slightly. Remove from pans. Do not peel off parchment. Once completely cool, place each cake right side up on a foam-board round, wrap in plastic, and refrigerate for at least 6 hours; this makes the layers firm and easy to handle. They can also be frozen at this point.

Step 3:
 If a cake doesn't bake level -- they often don't -- even it out with a serrated knife. Use a turntable to make it even all around.

Step 4:
Place a small dollop of the buttercream in the center of the cake. Put another foam-board round on top of the tier; invert the cake onto the foam board. Remove the original foam-board base and parchment. The bottom of the cake is now the top; the cake will remain on this foam-board round from now on.

Step 5:
Split the cake. Hold a serrated knife against the edge of the cake; rotate the turntable, working the knife through the cake.

Step 6:
Fill the bottom layer with jam filling one-eighth of an inch thick; don't use so much that the top layer slips and slides. Carefully replace the top layer, cut side down, and brush with sugar syrup. Then let set for 2 to 3 minutes.

Step 7:
Ice the top with buttercream using an offset spatula to give the tier a "crumb coat." This thin layer of icing will seal the cake. Start from the center and work out, making sure to push the buttercream over the sides of the tier.

Step 8:
Smooth the icing. The crumb coat will be covered by more icing later, so it doesn't have to be perfectly smooth at this point. Chill in the refrigerator to set the icing, about 30 minutes to one hour, until it doesn't stick to you when you touch it. Repeat steps three through eight with remaining tiers.

Step 9:
Before you begin working with the fondant, make sure all of your cakes are prepared by baking, filling, and crumb-coating each with a thin layer of buttercream icing. The tiers should be stored in the refrigerator at this point. This square cake calls for a square cake board; if you can't find one, have one cut out of flake board at a hardware store. Fondant must be at room temperature before you can use it.
Step 10:
Set up your work area. Your work surface should be completely smooth and lightly dusted with cornstarch to keep the fondant from sticking.

Step 11:
Start by kneading the fondant like you would knead bread dough. Knead it until it feels soft and pliable.

Step 12:
On the same work surface, roll out the fondant until it ideally has a thickness of about 1/4 to 1/8 of an inch. If you see any air bubbles, remove them by lightly poking them with a clean pin. Roll out enough fondant to cover the entire top and sides of the tier you are working on; excess fondant can be reused for the remaining tiers as long as it has not come into contact with buttercream.

Step 13:
Lift the fondant with both hands, and lower it onto the prepared cake tier, working quickly so the fondant doesn't dry out.

Step 14:
If necessary, dust your hands with cornstarch and smooth the top and sides of the cake, pushing out any air bubbles. The fondant will adhere to the buttercream crumb coat.

Step 15:
Run a pizza wheel or a knife along the edge of the cake, cutting away excess fondant. Complete process on remaining tiers…

Step 16:
Insert a 1/4-inch dowel vertically into the bottom tier of the cake; mark it 3/8 of an inch above the top of the tier. Remove it, and cut 8 dowel pieces to this length. These will be the supports for the next tier. Use 5 cut dowels to form a circle an inch and a half in from the edge of the tier that will be placed on top (hold an empty cake pan over the finished tier to figure out placement); use the other 3 to form a triangle inside the circle. Repeat the process on each tier -- except the top one -- using fewer dowels in different configurations as tiers get smaller. Do not place dowels directly in center of tiers. At this point, cakes can be refrigerated overnight.

Step 17:
Assemble the cake on its serving table. Dab some royal icing onto the center of the cake board, and place the bottom tier on it. Add the next tier, resting it on the dowels; the 3/8-inch space between the tiers will hide the bases of the flowers you'll use for decorations. Once all the tiers are stacked, cut a dowel a 1/4-inch shorter than the height of the cake. Using a knife, whittle one end to a point and gently drive it through the center of all the cakes and foam boards. Push the end all the way in so it doesn’t show.

Step 18:
Decorate cake as desired. There are many different techniques you can use and designs that you can create!! Enjoy!

Bibliography: http://www.marthastewartweddings.com/226740/wedding-cake-101-how-make-fondant-cake